Metra 99-5829CH Instrucciones De Instalación página 7

Heated Seat Functions (If equipped):
1. Upon first initialization of the 5829 you will have
to press and hold the driver heated seat button for
5 seconds to enable the heated seats.
Note: This process will be remembered by
the 5829.
2. Press the heated seat button once to turn the
heater to the low position. The LED will light up
green to indicate the low setting.
3. Press the heated seat button again and
the heater will go to the high position and the LED
will turn red.
4. Press the heated seat button again and the heater
will turn off.
99-5829CH
Installation Instructions
Dual Zone Temperature Controls
(If equipped):
1. Upon first initialization of the 5829 you
will have to press and hold the Auto button for
5-seconds to enable the automatic climate
control function to work.
Note: This process will be remembered by
the 5829.
2. To use the automatic climate control function just
press the Auto button and set the temperature
using the Temp adjustment button.
3. To activate the Dual climate control function press
the Pass Temp button.
4. The Dual icon will show on the display and there
will be an arrow pointing toward the passenger
allowing you to adjust the passenger side
temperature.
5. To switch to the driver temperature push the Pass
Temp button on the kit. The arrow will switch
to pointing to the driver and you can adjust the
driver temperature.
6. To exit Dual climate control mode push the Pass
Temp button for 3-seconds.
7
Clock Adjustment:
1. Press the menu button to access
on-screen menu.
2. Use the directional pad on the steering wheel to
scroll to "clock" in menu.
3. Adjust clock settings.
Note: If the vehicle has lost power, the OE radio must
be re-installed, powered up, and then shut down. If
this has not been done the menu function will not
work. If you are planning to remove power a memory
saver is suggested to be used to avoid doing this.