Remote Control - npg 400 Serie Guía De Usuario

Remote Control

Inserting Batteries in the remote
1.
Remove the battery com-
partment cover from the back
of the remote control by lifting
the cover
If the remote control does not work, check these
points:
• Are the polarities (+, -) correct?
• Are the batteries worn out?
• Is there an AC power failure?
• Is the power cord plugged in?
• Is there any interference or block near the
remote control sensor?
i
Warning:
All batteries (packed or in use) must not be exposed to high temperature like sun heat
or fire
Remote Control Reception Angle
Use your remote control within thr distance and angle range shown below
2.
Insert 2 AAA batteries, ma-
king sure the polarities (+ and
-)are aligned correctly
CAUTION:
•
•
•
•
•
8
3.
Replace the cover
Used batteries should be recycled
Keep out of children´s reach
DO NOT use new and old batteries together
Change both the batteries at the same time
When not using the remote control for a long
time, remove the batteries from the unit