Displaying And Deleting Measurements - Beurer medical BM 20 Instrucciones Para El Uso

• When the measurement has been taken, the pressure dis-
sipates very quickly. The pulse, the systolic and diastolic
blood pressure are displayed.
• Now press memory keys M1 or M2 to select the required
user memory. If you do not select any user memory, the
measurement result is assigned for storage in the user
memory which was last used. The symbol
appears accord ingly in the display.
6. Table for classification of blood pressure values (unit of measurement mmHg) for adults:
Range
Hypotonia (degraded blood pressure)
Normal range
Pre-hypertensive blood pressure range*
High blood pressure – degree I
High blood pressure – degree II
(*) Blood pressure range that might transfer to high blood pressure

7. Displaying and deleting measurements

Memory recall
You can recall stored results from the two user memories and
display averages.
• Press memory buttons M1 or M2. First the average is dis-
played of all the results held in this user memory. This is
indicated by reading .
• Continue pressing the memory button to recall other individ-
ual measurement results – the first result to appear is that of
or
Systolic
lower than 105
between 105 and 120
between 120 and 140
between 140 and 160
higher than 160
16
• Using the on/off button, switch off the blood pressure moni-
tor. The measurement result is then saved to the selected
user memory. If you forget to switch off the device, it
switches off automatically after approx. 3 minutes. Even
then, the result is still saved to the selected user memory.
Note: Measuring can be cancelled at any time by pressing the
on/off button.
Wait at least 5 minutes before any new measurement!
Diastolic
lower than 60
between 60 and 80
between 80 and 90
between 90 and 100
higher than 100
the most recent value measured. These individual values are
indicated by memory location numbers 1 to 30. After approx.
4 seconds, the date of the respective measurement result is
displayed and then the time after a further 4 seconds.
• Once 30 individual values are in the memory, the oldest value
is deleted in order to make room for the new measured value.
• Use the on/off button to turn off the device, or it will turn off
automatically after approx. 30 seconds.
Note: You can also use the two user memories to save meas-
urement results separately, e.g. in the morning and evening.
Action
Check with doctor
Self check
Check with doctor
Consult your doctor
Consult your doctor
Adapted from JNC 2003