Electrical Connection - Wilo IF-Module Stratos Instrucciones De Instalación Y Funcionamiento

English
7.2 IF-Module Stratos DP
Installation steps in accordance with Fig. 2:
• Remove the lid of the pump's terminal box
• Remove the cover (1)
• Install the IF-Module in the pump's terminal box (2)
• Push the connection plug in all the way (3)
• Remove the existing Pg 7 / Pg 9 screwed connections (4a)
• Install the accompanying metal Pg 7 and Pg 9 EMC cable glands (4b)
• Strip and prepare the shield and the core wires of the accompanying cable
2x2x0.22 mm², shielded pair (4c)
• Insert the cable (4d)
• Screw the cable gland into place (4e)
Electrical connection follows (see section below).

7.3 Electrical connection

WARNING! Danger of electric shock!
Electrical connection must be carried out by an electrician authorised by the
local electricity supply company and in accordance with the applicable local
regulations [e.g. VDE regulations].
• Carry out installation as described in the previous section
• Carry out electrical installation of the pump as specified in the relevant installa-
tion and operating instructions
• Check the technical specifications of the electric circuits being connected to
ensure they are compatible with the electrical specifications of the IF-Module
Terminal numbering as shown in Fig. 2, Pos. (3) from bottom to top
32 WILO SE 11/2013