Publicidad
Idiomas disponibles
Idiomas disponibles
heating tank (13) and the steam duct (4) reach high
temperatures and so must not be touched unless the
device is completely cold, as they could still cause se-
vere burns. Always pay maximum care and attention.
tivated, unplug the power cable (5) from the mains
socket, allow the device to cool completely, avoid
trying to turn it on again and refer to the section
"PROBLEMS AND SOLUTIONS".
tank, cleaning and limescaling the device and its parts,
refer to the paragraph "CLEANING AND MAINTE-
NANCE" in this instruction manual.
from the technical base (6) and prevent accidental
spillages, (this operation must only be performed
after unplugging the power cable from the mains
socket, when the device is switched off and has com-
pletely cooled down), detach the steam outlet (3) and
remove it by lifting it vertically using the handle pro-
vided (15) until it has been fully extracted from the
steam duct (4) (see fig. D)
in the technical base (6) during the cleaning opera-
tions, empty out the water contained in the heating
tank (13) by tilting the technical base (6) in the direc-
tion indicated by the two arrows (a) present in the
tank (13) (see fig. F).
water tank (2) or other parts of the device, or perform
any cleaning or maintenance operations when the
The surface of the heating plate(12), the
In case the emergency thermostat is ac-
For the operations involving filling the
To correctly remove the water tank (2)
To avoid accidental infiltrations of water
Do not move, lift or tilt the device, the
25
Publicidad
