Orion HCCA Serie Manual Del Usuario página 15

Five Channel Configuration
Channels 1/2 are configured for 2-channel stereo operation.
Channel 1/2 lowest recommended impedance is 2 Ω stereo. Lowest
recommended impedance is 2Ω stereo and 4Ω bridged mono.
Rear outputs must be set for full range operation.
Passive crossovers must be used on all components and frequen-
cies must not overlap.
LF
RF
Figure 19
Figura 19
Abbildung 19
NOTE: To get full output in this configuration, band limiting filters as
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits.
© 2009 Directed Electronics. All rights reserved.
LR
RR
Tri-Mode Six Channel Configuration
Lowest recommended impedance is 2 Ω stereo and 4Ω bridged
mono.
Front and rear outputs must be set for full range operation.
Passive crossovers must be used on all components and frequen-
cies must not overlap.
WARNING! Failure to observe these requirements may result in dam-
age to the amplifier.
LF
RF
Figure 20
Figura 20
Abbildung 20
NOTE: To get full output in this configuration, band limiting filters as
shown in this diagram may need to be used to prevent the impedance
from dropping too low and engaging protection circuits.
LR
RR
14