Foster 7380645 Manual De Instalacion Y Uso página 23

INSTALLATION
Important warnings
• Installation of the appliance into a kitchen worktop must be performed by an adequately qualified technician.
• Veneer or other finish of the piece of kitchen furniture into which the hob is to be built in should be treated with heat
resistant glue (100°C); otherwise, the worktop finish may be discolored or deformed.
• Ideally the appliance should be installed with plenty of space on either side. There may be a wall at the rear and a tall
unit or wall at one side. On the other side, however, no unit or divider should stand higher than the appliance.
NOT ALLOWED
• The distance between the appliance edge and the adjacent tall kitchen furniture element should amount to no less than
250 mm.
• All sizes and distances to be taken for the proper functioning of the appliance are shown in figures below.
• The kitchen furniture element underneath the hob should not be fitted with a drawer. If the kitchen furniture element as a
horizontal partition wall, it should be installed no less than min 20mm from the lower surface of the appliance. The space
between the partition wall and the appliance must be empty; no objects should be placed into that gap.
• Hanging, or wall-mounted kitchen elements should be installed high enough not to interfere with the work process.
• A minimum safety distance must be maintained between the appliance and the cooker hood above it. See the cooker
hood manufacturer's operating and installation instructions for details. If the manufacturer's instructions are not available
or, if there are any flammable objects (e.g. utensil rails, wall units etc) above the appliance, a minimum safety distance
of at least 800 mm must be maintained between them and the appliance below.
• Fit the wall units and cooker hood before fitting the appliance to avoid damaging it.
• The front part must have an opening of no less than 5 mm.
• The appliance must not be installed over a fridge, fridge-freezer, freezer, dishwasher, washing machine, washer-dryer or
tumble dryer.
• Only ovens fitted with a cooling fan may be installed underneath this appliance.
• Before installing an oven, the rear wall of the kitchen furniture element should be removed in the area of the appliance
cut-out. Furthermore, a gap of at least 5 mm should be left at the front side.
NOT RECOMMENDED
≥ 800 mm
a
≥ 50 mm
b
≥ 20 mm
c
≥ 80 mm
d
≥ 5 mm
e
≥ 30 mm
f
≥ 250 mm
g
NOT RECOMMENDED
23
RECOMMENDED