Auto Channel Scan; Language Selection - Sylvania LD370SC8S El Manual Del Propietario

I
NITIAL SETTING
And select the sound input for the HDMI jack if your
TV is connected to a HDMI device.
(Refer to "HDMI Audio" on page 27.)
• LANGUAGE
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to "Language Selection" on page 14.)
• DVD
You can customize some functions for the disc
playback. Make sure the player is in stop mode.
(Refer to "SETTING DVD" section on page 37.)

Auto Channel Scan

If you switch wires (e.g., between antenna and CATV) or if you move the
unit to a different area after the initial setting, or if you restore the DTV
channel you deleted, you will need to perform auto channel scan.
Before you begin:
Make sure if the unit is connected to antenna or cable.
1
Press [SETUP] to display the main menu.
2
Use [Cursor K / L] to select "CHANNEL" , then press
[ENTER].
3
Use [Cursor K / L] to select "Autoscan", then press
[ENTER].
Use [Cursor K / L] to select an appropriate option, then
press [ENTER].
14
EN
You can choose English, Spanish, or French as your on-screen language.
1
2
Channel
Channel
Autoscan
Channel List
Manual Register
Antenna
3
Autoscan
Autoscan
Back
Autoscan will rescan all channels.
This may take a while to complete.
Air
Select the destination of "ANT.IN" jack.
Cable
Cable
Air
1hour
Or
Cable
ANT.IN
4
• When aerial antenna is connected, select "Air".
• When connected to CATV, select "Cable".
• Scanning and memorizing of channels start
automatically.
Now the system is scanning for channels, please wait.
• When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
Note:
• If you connect the cable system directly, contact the CATV installer.
• If you press [POWER] or [SETUP] during auto channel
scan, the setting will be canceled.
• Channel settings will be saved even if the power fails.
• If you need the English menus instead of the Spanish
or French menus you are having, press [SETUP]. Use
[Cursor K / L] to select "IDIOMA" or "LANGUE", then press
[ENTER]. Use [Cursor K / L] to select "English", then press
[ENTER]. Press [SETUP] to exit the main menu.
• With regard only to the digital channel, even after the
scanning is complete if you unplug the AC power cord
before turning off the unit by pressing [POWER], the
channel setting may be lost.

Language Selection

Press [SETUP] to display the main menu.
Use [Cursor K / L] to select "LANGUAGE", then press
[ENTER].
Use [Cursor K / L] to select "English", "Español" or
"Français", then press [ENTER].
Press [SETUP] to exit.
72%
Analog channels 10ch
Digital channels 6ch
SETUP
Exit
Language Language
Select the language for setup display. English
Español
Elija el idioma de ajuste.
Français
Sélectionner langue écran config.