Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch PST 800 PEL Manual Original

OBJ_BUCH-1065-001.book Page 19 Tuesday, October 6, 2009 9:00 AM

Technical Data

Jigsaw
Article number
"Cut Control"
Stroke rate control
Orbital action
Rated power input
Output power
Stroke rate at no load n
0
Stroke
Cutting capacity, max.
– in wood
– in aluminium
– in non-alloy steel
Bevel cuts (left/right),
max.
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 85 dB(A);
Sound power level 96 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Cutting board: Vibration emission value
2
a =13 m/s , Uncertainty K=3 m/s
h
Cutting sheet metal: Vibration emission value
2
a =7 m/s , Uncertainty K=1.5 m/s
h
Bosch Power Tools
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
PST 800 PEL
may be used to compare one tool with another.
3 603 CA0 1..
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
W 530
vibration emission may differ. This may signifi-
W 290
cantly increase the exposure level over the total
working period.
-1
min 500–3000
An estimation of the level of exposure to vibra-
mm 20
tion should also take into account the times
when the tool is switched off or when it is run-
mm 80
ning but not actually doing the job. This may sig-
mm 12
nificantly reduce the exposure level over the to-
mm 5
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
° 45
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
kg 1.9

Declaration of Conformity

/II
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 21.09.2009
2
,
2
.
English | 19
Dr. Eckerhard Strötgen
Head of Product
Certification
2 609 003 951 | (6.10.09)