Before The First Use - Kiwi KVS 9975 Manual Del Uso

BEFORE THE FIRST USE

• Take the appliance and accessories out the box. Remove the stickers, protective foil or plastic from the device.
• Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around the device. This device
is not suitable for installation in a cabinet or for outside use.
• Put the power cable into the socket. (Note: Make sure the voltage which is indicated on the device matches the
local voltage before connecting the device. 220-240V~50/60Hz)
• When the device is turned on for the first time, a slight odor will occur.This is normal, ensure adequate ventilation.
This smell is only temporary and will disappear soon.
USE
WELDING A TUBE FILM
• The film width may not exceed 28 cm. Otherwise it cannot be welded correctly.
• Use only nylon-PE films with a structure (points or grooves) on one side and a thickness of approximately 0.17 - 0.29
mm (170 - 290 μ). Otherwise the weld seam will not be tight and the appliance may be damaged. You can recognise
films of this type from the information on the packaging. The quality of the weld seam will vary depending on the type
and thickness of the film.
• The supplied film is suitable for temperatures between -20°C and +100°C.
1) Cut the desired length for your bag from the tube film using a pair of scissors. Cut as straight as possible.
2) Open the appliance lid (1) by pressing the lid release (8) and opening the lid (1) upwards.
3) Lay the open end of the bag as far into the appliance so that the opening of the bag is located centrally under the
lower sealing ring (5). The bag should be inserted no further than the rear limiters (6) and must lie between the front
limiters (7). If the bag lies over one or both of the two limiters (7), then the bag cannot be correctly welded.
CAUTION – PROPERTY DAMAGE!
If the red control lamp (11) does not go out after a maximum of 10 seconds, there is a fault with the appliance.
• Remove the plug from the mains power socket immediately. Do not attempt to repair the appliance yourself.
Contact the Customer Service department.
6) Open the appliance lid (1) by pressing the lid release (8) and flipping the lid (1) upwards. Remove the bag. This is
now sealed at one end.
NOTE
• Ensure that the weld seam is properly closed. A correct weld seam should be a smooth, straight stripe without any
creases.
7) Fill the bag. You must leave at least 6 cm of the bag free up to the edge to be welded.
CAUTION – PROPERTY DAMAGE!
• Fill the bag so that no food scraps or liquids can leak out during welding and get it into the appliance.
8) If you do not want to vacuum the bag, you can now weld the other, open side.
NOTE
• Wait 15 seconds before sealing the next bag to allow the appliance to cool down.
During this cool-down phase, you cannot start the "seal" function.
NOTE
• The bag opening must lie flat on the welding wire (4). Otherwise the
welding does not work properly.
4) Close the appliance lid (1). The press seal (10) presses the bag onto
the welding wire (4), to create a smooth seam. Ensure that both corners
of the appliance lid (1) click closed. If necessary, press them down once
again on the markings so that the appliance lid (1) clicks into place and
locks shut.
5) Press the button (12). The red control lamp (11) lights up. As soon as
the
sealing process is finished, the red control lamp (11) goes off.
NOTE
• You can halt the sealing process at any time by pressing the button (13).
The red control lamp (11) goes out.
3
KVS 9975 Instruction Manual