Safety Considerations; Important; Hazardous Location Considerations - Rockwell Automation Allen-Bradley SLC 5/03 Instrucciones De Instalación

Safety Considerations

ATTENTION
For general recommendations concerning installation safety requirements and
safety related work practices, refer to the requirements specific to your region.
• Europe: Reference the standards found in EN 60204 and your national
regulations.
• United States: refer to NFPA 70E, Electrical Safety Requirements for
Employee Workplaces.

IMPORTANT

Hazardous Location Considerations

This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or
non-hazardous locations only. The following WARNING statement applies to use in
hazardous locations.
WARNING
SLC 5/03, SLC 5/04, and SLC 5/05 Modular Processors
Never install, remove, or wire any module while power is applied. Also, do not
expose processor modules to surfaces or other areas that may typically hold an
electrostatic charge. Electrostatic charges can alter or destroy memory.
See page 13 for information on proper battery handling, storage, and
transporting.
EXPLOSION HAZARD
• Substitution of components may impair suitability for Class I, Division 2.
• Do not replace components or disconnect equipment unless power has
been switched off or the area is known to be non-hazardous.
• Do not connect or disconnect components unless power has been
switched off or the area is known to be non-hazardous.
• This product must be installed in an enclosure. All cables connected to the
product must remain in the enclosure or be protected by conduit or other
means.
• All wiring must comply with N.E.C. article 501-4(b).
Publication 1747-IN009E-MU-P - April 2007
5