Truper SOMI-210X Manual De Instrucciones página 41

Troubleshooting
Problem Cause
The welding pearl is • Welding current is too low.
very narrow and bulky. • Welding speed is too fast.
The welding pearl is • Welding current is too high.
too wide. • Welding speed is to slow.
• The arc is too long.
The weld has low • Welding speed is too slow.
penetration. • The arc is too long.
The weld has too • Welding current is too high.
penetration. • Welding speed is to slow.
• The arc is too long.
If after all the recommended actions have been carried out the problems persist,
contact a
Solution
• Increase the speed and current to the micro wire.
• Move the torch slower and / or make circular
movements or zig zag movements with the nozzle.
• Diminish the micro wire current and speed .
• Move the torch faster and / or make less circular
movements or zig zag movements with the nozzle.
• Correct the distance between the nozzle and the
work piece (from 0,3" to 0,4").
• Increase the speed and current to the micro wire.
• Correct the distance between the nozzle and the
work piece (from 0,3" to 0,4").
• Decrease the speed and current to the micro wire.
• Move the torch faster and / or don't make circular
movements or zig zag movements with the nozzle.
• Correct the distance between the nozzle and the
work piece (from 0,3" to 0,4").
Authorized Service Center.
19
ENGLISH