Publicidad
Idiomas disponibles
Idiomas disponibles
cylinder. Then remove the hexagonal joint (see figure 5).
4 Remove the gasket from its housing (see figure 6).
5 Disassemble the spigot by following the order given (see
figure 7).
6 Remove the drip tray and empty it.
figure 5
figure 6
figure 7
7 Remove the flow restrictor from the bowl (see figure 8).
6. 4. 2 CLEANING
IMPORTANT
Do not wash any part of the machine in a dishwasher.
ATTENTION
Before any cleaning operation, always disconnect the
dispenser from the power source.
1 Pour about one gallon of 90-110 °F water and mild
detergent into a bucket, following the manufacturer's
instructions. A solution that is too strong can, in fact, damage
the parts to be washed, while a solution that is too diluted may
not clean enough. Do not use abrasive detergents.
IMPORTANT
In order to prevent damage to the dispenser, use only
detergents that are compatible with the plastic parts.
2 Use a suitable brush and wash all the parts in contact with
the beverage thoroughly with the detergent solution.
ATTENTION
While washing the dispenser, do not use excessive
amounts of water around the electrical components. This
could cause electric shocks or damage to the dispenser.
3 Wash the evaporator cylinders using a soft brush.
4 Rinse all parts washed using tap water.
6. 4. 3 SANITIZING
Sanitizing must be done immediately before starting up the dis-
penser. Do not allow the dispenser to remain idle for a long time
after sanitation.
1 Before starting the procedures described below, wash your
hands with antibacterial soap.
2 Prepare 2 gallons of Stera-Sheen sanitizing solution
according to the manufacturer's instructions.
3 Immerse all parts to be sanitized in the solution for the time
indicated by the product manufacturer.
7
figure 8
Publicidad
