Assembly And Use For The Single Serve Cup - Ninja BL830 Guia Del Usuario

Assembly and Use of the Nutri Ninja
WARNING: Handle the Nutri Ninja Blade Assembly with care, as the blades are sharp.
WARNING: Never leave the appliance unattended while in use.
WARNING: Remove utensils prior to processing. Failure to remove may cause the Nutri
Ninja Cup to be damaged or to shatter, which may cause personal injury.
CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup,
resulting in risk of the user being burned.
CAUTION: Remove the Nutri Ninja Blade Assembly from the Nutri Ninja Cup upon
completion of blending. Do not store ingredients before or after blending in the Nutri
Ninja Cup with the blade assembly attached. Some foods may contain active ingredients
or release gases which will expand if left in a sealed container, resulting in excessive
pressure buildup that can pose a risk of injury. For ingredient storage in the cup, use only
the Sip & Seal Lid to cover.
®
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig. 9 Fig. 10
1 Review warning and caution statements above
before proceeding to number 2.
2 Place the motor base on a clean, dry, level surface
such as a counter or table top.
3 Add ingredients to the Nutri Ninja Cup.
NOTE: Do not overfill! To avoid spilling, do not
add ingredients past the "Max" fill line.
4 Place the Nutri Ninja Blade Assembly onto the cup
and tightly screw it on clockwise until you have a
good seal. (Fig. 9)
5 Turn the Nutri Ninja Cup upside down and place it
onto the motor base, aligning the tabs on the cup
with the motor base. (Fig. 10) Turn clockwise until
the cup locks in place, the unit is ready for use.
(Fig. 11)
6 Turn the Variable Speed Dial to the Single Serve
icon. The Nutri Ninja Cup only operates at one
speed regardless of which number is chosen on the
dial. Press down on the "Start/Stop/Pulse" toggle
PULSE
Fig. 11
For best results, use short "PULSES"... Practice makes perfect!!
Cup
®
REMOVAL
Fig. 12
in short intervals until you have reached your
desired consistency. (Fig. 11)
7 When you have reached your desired consistency,
turn the Nutri Ninja Cup counter-clockwise
(Fig.12) and pull straight up to remove. (Fig. 13)
8 Turn the cup upright and remove the Nutri Ninja
Blade Assembly by twisting the blade assembly
counter clockwise. (Fig. 14)
9 Do not store blended contents with the Nutri Ninja
Blade Assembly attached.
10 Place the Sip & Seal
®
twist on to seal and enjoy!
11 For storage, only use Sip & Seal
12 Be sure to store the Nutri Ninja Blade Assembly
attached to an empty cup when not in use.
13 Make sure that the motor base is unplugged when
not in use.
Fig. 13 Fig. 14
lid onto the Nutri Ninja cup,
lid to cover.
®
ninjakitchen.com
14