Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Chute
f
"_
Thedistancesnowis throwncan be adjustedby changingthe angle of
the upperchute.Todo so:
1.
Stopthe engineby removingthe ignitionkeyand loosenthe
plasticwingknobfoundon the left sideof the chuteassembly.
2.
Pivotthe chute upwardor downwardbeforeretightening thewing
knob.See Figure14.
Auger Control
Priorto operatingyoursnowthrower,carefullyread and followall
instructionsbelow.Performall adjustments to verifyyoursnow
throweris operatingsafelyand properly.
Checktheadjustmentof the augercontrolas follows:
1.
Theaugercontrol is locatedon the left handle.See Figure15
inset.Whentheauger controlis releasedand in the disengaged
"up"position,the cableshouldhavevery little slack. It should
NOT be tight.
2.
In a well-ventibtedarea,start the snowthrowerengine.Referto
Startingthe Enginein the Operationsection.
3.
Whilestandingin the operator'sposition(behindthe snow
thrower),engagethe augers.
4.
Allowtheaugersto remainengagedfor approximately ten (10)
secondsbeforereleasingthe augercontrol.Repeatthis several
times.
5.
With theauger controlin thedisengaged"up" position,walkto the
front of the machine.
6.
Confirmthat the augershavecompletelystoppedrotatingand
show NOsignsof motion.If anyauger showsANY signof
rotating,immediatelyreturnto the operator'spositionand shutoff
the engine.Waitfor ALL movingparts to stop beforeadjustingthe
augercontrol.
7.
Toreadjustthecontrolcable, loosentheupper hexbolt on the
augercablebracket.See Figure15.
8.
Positionthe bracketupwardto providemoreslack(or downward
to increasecabletension).
9.
Retightenthe upperhex bolt.
10. Repeatsteps2-6 aboveto verifyproperadjustmenthasbeen
achieved.
Figure14
\
\
\\
\
Figure15
J
13
Publicidad
Tabla de contenido
