Pictograms; Transport; Assembling Instructions; To Set The Machine - Sima DAKAR PLUS MONOFASICA Manual De Instrucciones Original

2.1 PICTOGRAMS

Pictograms included in the machine entail the following:
READ INSTRUCTIONS
MANUAL
USE SAFETY GLOVES

2.2 TRANSPORT

The machine is packed in the factory on a pallet, easy to lift with forklifts or hand pallet trucks. Due
to its dimensions and weight (See the technical features table in this manual), it is possible to transport it in light
vehicles.
When it is necessary to move the machine within the workplace once it has been unpacked, it is
recommended to empty the water from the tray before moving the machine to avoid possible splatter. Make also sure
the screws fixing the legs to the tray are perfectly tight to avoid them to fall off when lifting the machine.
When it is needed to transport the machine for too long distances by vehicles, cranes or other means of
elevation, the latter should be safe.
By lifting the machine with cranes or hoists, normalised slings must be used. These are chosen en function of
the required work load limit, the way of use and the nature of the load. The choice is correct if special norms of use
are respected.
ATTENTION: To avoid any possible danger, stay away from elevated loads and be careful with their possible
displacement during transport, whether during lifting or mooring. Therefore, it is essential to choose the correct slings
and remain particularly vigilant in sensitive operations (elevation, coupling, mooring or discharging).

3. ASSEMBLING INSTRUCTIONS

DAKAR PLUS models are delivered in individual reinforced packing, containing in its interior the necessary
accessories for its correct mounting.
_ 4 legs and its 4 screws (see explosion of material Nº19)
_ 1 hexagonal key and a pricker (see explosion of material Nº10)

3.1 TO SET THE MACHINE

DAKAR PLUS models are supported with four legs intended to give the machine the necessary stability. These
legs are meant to be easily mounted and dismounted to facilitate the transport and the storage of the machine.
To place machine model in its normal position, it is necessary to place the four legs in its frame (P, Fig.2)
putting them up in the corresponding leg supports (T, Fig.2) of the tray using screws provided.
USE HELMET AND EYE AND
AUDITIVE PROTECTION
USE SAFETY BOOTS
-6-
ENGLISH