Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
USE
When connecting the plug to the mains outlet, the minibar starts operating immediately, unless the tem-
perature adjusting knob is set to "0" (zero)" (see figure 03).
Temperature setting
The knob for the temperature adjusting thermostat is located in the upper part of the internal liner of the
refrigerator.
To set the internal temperature, adjust the control knob according to the ambient temperature or based on
the use the refrigerator is intended to.
The temperature control range is comprised of the following levels:
• position 0 = refrigerator off
• position 1 = minimal refrigeration (higher internal temperature)
• position 2 = medium refrigeration (intermediate internal temperature)
• position 3 = maximum refrigeration (lower internal temperature)
In the niche versions, the door can be hooked onto the leaf of the cabinet housing through the drawing line
which allows for simultaneous opening (dragging system). If the door opens in the opposite direction
from the leaf of the cabinet, proceed as follows (see figure 04):
• remove the protection A that covers the upper plate B;
• unscrew the screws fastening the plate B to the refrigerator structure and remove that plate;
• unscrew the foot C and the screws fastening the lower plate D, and remove that plate;
• remove the protection E and the foot F;
• assemble the lower plate D and the foot C in a position opposite to the previous one;
• assemble the upper plate B and its protection A in a position opposite to the previous one;
• assemble the protection E and the foot F in a position opposite to the previous one;
• put the plate A back using the relevant screws.
APPLYING THE DRAFT
(see figure 05)
The draft is a device - consisting of two parts, A and B - which connects the door of the Minibar to the door
of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
• screw the part A onto the door of the Minibar;
• open the door of the Minibar by 90°;
• screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture, and fit it into the
part A so it can work as a sliding guide;
• fasten the lower part of the refrigerator to the base of the cabinet containing it by means of the brackets C.
10
BREEZE
BREEZE_29-09-2017
Publicidad
