Rear Panel - Fender Cyber–Twin SE Instrucción De Funcionamiento

Rear Panel Overview
12
R R e e a a r r P P
R R e e a a r r P P
w w w w w w . . f f e e n n d d e
a a n n e e l l O O v v
a a n n e e l l O O v v
AA. POWER
Switches Power on or off to the Cyber-Twin
BB. IEC POWER CORD SOCKET
Connection for the included power cord. Connect to a grounded AC outlet
in accordance with the voltage and frequency ratings listed on the rear
panel of your Cyber–Twin SE™.
CC. FOOTSWITCH JACK
Connect the included Fender
cable provided. Use this footswitch to remotely activate the Quick Access
presets. Although the footswitch uses a MIDI type cable, the footswitch is
an analog device and should only be connected to the FOOT SWITCH jack.
DD. EXPRESSION PEDAL JACK
Connection for a standard expression foot pedal (optional) used to remotely
control any of the following parameters:
MIDDLE, BASS, PRESENCE, REVERB, MASTER, any Reverb parameter, or
any effect parameter.
programmable through the AMP edit mode (see page 15).
EE. REVERB / FX BYPASS
Connection for the included one-button footswitch. Use this footswitch to
remotely bypass Reverb and/or effects in one of 8 input/output
configurations. Or, if Vibratone is the active effect, you can switch between
rotor speeds (set Reverb/FX bypass parameter to Vibro Fast/Slow).
Reverb/FX bypass is preset programmable through the AMP edit menu (see
REVERB / FX BYPASS on page 15)
e r r . . c c o o m m
e e r r v v i i e e w w
e e r r v v i i e e w w
® 4–button footswitch using the MIDI type
Expression pedal assignment is preset
w w w w w w . . m m r r g g e
® SE amplifier.
GAIN, VOLUME, TREBLE,
e a a r r h h e e a a d d . . n n e e t t