Know Your Product; Symbols On The Product - Ryobi ROS300 Traducción De Las Instrucciones Originales

KNOW YOUR PRODUCT

See page 81.
1. Power cord sleeve
2. Speed control dial
3. Live tool indicator
4.
5. Sander cover
6. Dustbox cover
7. Dustbox container
8. Sanding paper
9. Insulated grasping surface
MAINTENANCE
WARNING
The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
WARNING
When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use of
any other parts may create a hazard or cause product
damage.
WARNING
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Electrical tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to
accelerated wear and possible premature failure,
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc. We
do not recommend using the product for extended work
on these types of materials.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation. If operation is dusty,
also wear a dust mask.
2
If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
the unit under normal operating conditions. Therefore, no
further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for
friendly recycling.

SYMBOLS ON THE PRODUCT

Safety Alert
V Volts
Hz Hertz
Alternating current
W Watts
no
Revolutions or reciprocations per minute
Class II tool, double insulation
CE Conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Pad size
Orbital diameter
Please read the instructions carefully before
starting the product.
Wear ear protection.
English