GHL MixRite Manual Del Usuario página 4

Installing the MixRite on a Direct Line (in line)
1. Install onto the water line using swivel connectors and ensure
that the water flows into the MixRite in the direction indicated by
the arrows printed on the MixRite.
2. Install a 50-75 mesh (250-300 micron) filter between the valve
and the injector intake.
3. Valves have to be installed at the water line entry and exit; in
order to stop the pump's action – you should close the Valve at
the entry point.
4. Position the drawing pipe into the additive container. Ensure that
the suction pipe filter is set several millimeters above the
container's bottom. Check to ensure that the suction pipe is not
bent or folded.
Correct Installation
I-870
Rev G - 37915
Installation of the MixRite
Install the MixRite on a Direct Line (In Line)
www.ghlinc.com
Incorrect Installation
Page 4 of 36