Alarm Management - Palazzetti ECOFIRE Serie Manual De Instalación, Uso Y Mantenimiento

11 ALARM MANAGEMENT

If a malfunction occurs, the following procedure is activated:
1) audible alarm (beep);
2) one of the following system LEDs come on:
3) if the problem concerns an error, the stove will switch off.
Pressing and holding the "cancel" button
ERROR/
WARNING CODE
E001
E002
E004
E101
E108*
E109
E110
E111
A001
A002
A007
----
----
* Only for the models equipped with safety microswitches on the door or on the hopper lid.
After having checked the type of message, the alarm can be reset by pressing the
on/off button for a few moments.
If the error code is "( ", before resetting the alarm, manually reset the thermostat
located on the rear of the stove (Fig. 11.1) WKLV VKRXOG EH FDUULHG RXW E\ DQ
DXWKRUL]HG WHFKQLFLDQ  Then the stove can be started again.
cod. 00 477 1430 - 04/2013 - Palazzetti - PN - Italy
USE AND & MAINTENANCE
DESCRIPTION
Faulty control panel
Remote control signal communication error
Communication error
Failed ignition error
Safety error
Pressure error or thermal safety
Temperature probe malfunction
Flue gas temperature probe malfunction
Low pellet level LFRQ ÀDVKLQJ
Scheduled maintenance warning LFRQV
ÀDVKLQJ
Pressure sensor malfunction LFRQ ÀDVKLQJ
Clean stove
Failed ignition error
;
shows the error code on the display:
POSSIBLE CAUSES
Control panel fault
Control panel fault
Connection cable between board and control panel
interrupted or detached.
,I WKLV DSSHDUV ZKHQ FKDQJLQJ FRQ¿JXUDWLRQ LJQRUH
the error
No pellets
Pellet quality
Faulty ignition system
Burn pot dirty
Problems with the heating system
Problems with the pump
Door or hopper lid open
Flue gas exhaust system dirty
Seal gaskets worn
,QVXI¿FLHQW FRPEXVWLRQ DLU
Problems with overheating in the pellet hopper
Faulty air temperature probe
)DXOW\ ÀXH JDV WHPSHUDWXUH SUREH
Pellets running out
The stove periodically requires maintenance to be
SHUIRUPHG E\ D TXDOL¿HG WHFKQLFLDQ
Pressure sensor or board fault.
&RPEXVWLRQ FKDPEHU EXUQ SRW RU ÀXH JDV H[KDXVW
system dirty.
Pressure measuring tubes detached or blocked.
Combustion air intake blocked.
No pellets; Faulty ignition heater; Worn gaskets;
Incorrect burn pot position
LED
Fig. 11.1
51/134