Resetting To Factory Defaults (Reset); The Learn Function (Learning); Programming Via The Learn Function (Learn Key) - Silvercrest SFB 10.1 C3 Manual De Instrucciones

Resetting to factory defaults (RESET)

1. Press and hold the
2. Press
3. Press
4. Press
"MODE".
5. Press to confirm your entry.
Choosing "ALL RESET" will restore the settings for all devices. The
procedure is as follows:
6. After choosing "ALL RESET", press
read „CONFIRM RST".
You can still press
7. Press
returns to the start window.
The day of the week and the time are not reset.
Choosing "MODE" restores the settings for the selected device only. The
procedure is as follows:
8. After you confirm your selection "MODE" by pressing
display shows the device currently selected. Select the device you
want by pressing the corresponding device button.
9. After confirming your choice with
"CONFIRM RST".
You can still press
10. Press
returns to the start window.
Press to go back one menu level. To return to the start window,
press one of the device buttons.

The learn function (LEARNING)

Programming via the learn function (LEARN KEY)

This function allows the remote control to learn individual buttons for a
selected device.
1. Press the device button for the device that you wish to program.
2. Press and hold the
3. Press
4. Press
5. The display reads "SELECT KEY".
All buttons except the device buttons support learning.
6. Press the button that you wish to learn a command. The display
reads "WAITING".
7. Place the original remote control so its IR LED and the IR LED (2) of
your 10-in-1 remote control face each other and are no greater than
5 cm apart.
8. Next press the button on the original remote control from which you
wish to copy the signal. The successful detection of the button code is
indicated by "SUCCESS" on the display.
, select "CONFIGURE" and press
, select "RESET" and press
and choose between "ALL RESET" and
to cancel the reset at this point.
to confirm your entry. The display reads "OK" and then
to cancel the reset at this point.
to confirm your entry. The display reads "OK" and then
, select "LEARNING" and press
, select "LEARN KEY" and press
button for 3 seconds.
to confirm. The display will
button for 3 seconds.
SilverCrest SFB 10.1 C3
to confirm.
, the display will read
to confirm.
to confirm.
English - 83
to confirm.
, the