Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8
1.
2=
3=
LEVELING
THE DISHWASHER
Open the door and place the level against the top of the
tub on the inside and check
if the the dishwasher
is level.
If it is not level, rotate the leveling legs at the bottom
front
of the dishwasher
until the dishwasher
is level.
See the first note below for instructions
on adusting
the
height of the front legs.
Use the level to check if the dishwasher
is level front to
back, as shown in the figure to the right.
If the dishwasher
is not level front to back, adjust the
height of the rear leg until the dishwasher
is level.
See the second
note below for instructions
on adusting
the the rear leg.
Open the door of the dishwasher
and
check
if both the tub and door clearances
are correct.
If not, rotate the leveling legs on the
bottom front of the dishwasher.
You can aslo check this by placing a level
against
an inside front vertical surface
of
the tub.
ii! i
{_
f the leveling legs are rotated to the right (counter
clockwise),
they are loosened
and the front of the
dishwasher
is raised. If they are rotated to the left
(clockwise),
they are tightened
and the front of the
dishwasher
is lowered.
To adjust the height of a rear leg, turn the Hexbolt
(at
the front of the base) to the left to raise the back of the
dishwasher
using the proper tool (Hex L-wrench
or
similar tool).
/_
Before you move the dishwasher
for installation,
make sure to adjust the height of the
.......
_
legs so the legs are as short as possible.
This prevents the legs from breaking.
Level the
dishwasher
by adjusting
the height of the legs after you have the dishwasher
in place.
[_
hat if the product
is installed unleveled
or with the leg missing, the door may not close
completely,
causing
a leak of steam or water.
installing the dishwasher
15
D1,*Tg0H9950US
00151A
06 EN
150216illdd
Sec3:15
Publicidad
Tabla de contenido
