Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 12 COMPLETING
THE iNSTALLATiON
1. Open the door and remove all foam, paper packaging,
and unnecessary
parts.
2. Turn on the circuit breaker you turned off before you began the installation,
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher,
and then select and run a cycle.
Check if the power turns on correctly
and if there is any water leakage while the dishwasher
_is
operating,
tf no problem
is found, turn off the dishwasher,
and then go to Step 5 below.
If you encounter
a problem,
turn off the dishwasher,
close the water supply valve, and then
refer to the user manual or contact
a service center 1-800-SAMSUNG
(726-7864).
Make sure to check for water leakage on both ends of the water supply
line and drain hose
OAOT,O.
connector.
5.
Locate the sound absorber
in front of base refer to the figure below
(ON SOME MODELS).
[_
heck it the black rubber skirt (*applicable
models only) should
be located
inside, and then
sound absorber
will be covered
it.
i
/
6. Confirm that the kick plate gasket is on the bottom
of the kick plate. To install the kick plate,
refer to the fi gure below.
installing the dishwasher
21
D1,*Tg0H9950US
00151A
06 EN
150216illdd
See3:21
Publicidad
Tabla de contenido
