Troubleshooting - HoMedics UHE-CM15 Manual De Instrucciones E Información De Garantía

Troubleshooting

PROBLEM POSSIBLE CAUSE
Power Light • Unit is not plugged in
is off
• No power at outlet
Peculiar • If new unit
Odor
• If unit is in use, the odor
may be a dirty water
reservoir, old tank water
or an old wick
Excessive • Unit is not level
Noise
• Low water level
• Wick was not soaked
SOLUTION
• Plug unit in
• Push POWER button to turn the
power on
• Check circuits, fuses, try a
different outlet
• Empty any water and clean and
refill tank
• Replace wick
• Place unit on a flat, even surface
• Check the water level. Refill the
reservoir if the water is low.
• Remove wick, soak for 2 minutes
and replace wick
10
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
1 1