Getting Started; Detaching The Front Panel; Attaching The Front Panel; Switching The Fm/Am Tuning Step - Sony CDX-G1170U Manual De Instrucciones

RM-X211 Remote commander
The VOL (volume) + button has a tactile dot.
 ATT (attenuate)
Attenuate the sound. Press again to cancel the
attenuation.
 SOUND
Open the SOUND menu directly.
MENU
Press and hold to open the setup menu.
 ///
Select a setup item, etc.
ENTER
Enter the selected item.
/ (prev/next)
+/– (album +/–)
 VOL (Volume) +/–
Remove the insulation film before use.

Getting Started

Detaching the Front Panel

You can detach the front panel of this unit to
prevent theft.
1
Press and hold OFF  until the unit turns
off, press the front panel release button
, then pull the panel towards you to
remove.
Caution alarm
If you turn the ignition switch to the OFF position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.

Attaching the front panel

Switching the FM/AM Tuning
Step
Set the FM/AM tuning step of your country. This
setting appears only while the source is off and
the clock is displayed.
1
Press MENU, rotate the control dial to
select [SET GENERAL], then press it.
2
Rotate the control dial to select [SET
TUNER-STP], then press it.
3
Rotate the control dial to select from [SET
50K/9K], [SET 100K/10K] or [SET 200K/
10K], then press it.
5
GB