Makita SKR60 Manual De Instrucciones página 5

Rotation Speed
The head rotates at three speeds; 150 rpm is the
default setting. To change rotation speed, press the
rd
3 key (speed/scan) on the keypad. Press once for
400 rpm; press again for 600 rpm (it takes a few
seconds to reach full acceleration). Press again to
stop rotation.
The laser beam is more visible in slow motion.
To move the beam left or right, use the remote
control with the laser in scanning mode. It's also
possible to stop the rotation and point the beam
manually.
Scanning
Scanning mode allows you to see the beam easier at
a distance. To switch from rotation to scan, press the
R/S key. The scanning beam has three lengths, or
rd
angles: 2, 8, and 25. To change, press the 3 key
(speed/scan) on the keypad.
When using the laser, it is important to check that it
has not been moved and that your setting is still
accurate.
5