Publicidad
Idiomas disponibles
Idiomas disponibles
[o)_J_P_o)_l
Pull starter handle rapidly.
Figure 7
6.
As the engine
warms
up, move
choke
control
to 1/2 choke posi-
tion. When
engine
runs smoothly,
move choke
lever
to OFF Position.
NOTE"
Allow the engine
to warm
up for
several
minutes
before blowing
snow
in
temperatures
below
0°R
How To Start A Warm Engine
If restarting a warm engine after a short
shutdown, leave choke at "OFF" and do
not push the primer button.
If the en-
gine fails to start, follow the Cold Start
instructions.
FROZEN STARTER
If the starter is frozen and will not turn
the engine, follow the steps below.
1. Pull as much starter rope as pos-
sible out of the starter.
2.
Release
the starter
handle
and let it
snap back against
the starter.
Re-
peat until the engine
starts.
Warm
engines
will cause condensation
in cold weather.
To prevent
possible
freeze-up
of recoil starter
and engine
controls,
proceed
as follows
after each
snow
removal
job.
1.
With engine
off, allow engine
to coo!
for several
minutes.
Pull starter
rope very slowly
until re-
sistance
is felt, then
stop. Allow the
starter
rope to recoil. Repeat
three
times.
With the engine
not running,
wipe all
snow
and moisture
from the carbu-
retor cover
in area of controls
and
levers.
Also,
move the choke
control
and starter
handle
several
times.
,_
WARNING: Never run en-
gine indoors or in enclosed,
poorly ventilated areas.
En-
gine exhaust contains CARBON
MONOXIDE, AN ODORLESS AND
DEADLY GAS, Keep hands, feet,
hair and loose clothing away from
any moving parts on engine and
snow thrower.
•
Engine parts, especially the muf-
fler, become extremely hot. Se-
vere thermal burns can occur on
contact. Allow the engine to cool
before touching.
•
Never allow children to operate
the snow thrower. Never allow
adults to operate the snow throw-
er without proper instruction.
•
Keep the area of operation clear
of all persons, particularly small
children and pets.
•
Never leave the enowthrower un-
attended while the engine is run-
ning. Anyone operating the en-
gine or equipment
must carefully
read and understand the operat-
ing instructions.
F-051009C
12
Publicidad
