Publicidad
Idiomas disponibles
Idiomas disponibles
[.,,."_o,,_
F_I Z IB]P'_"_
HOW TO REMOVE
THE TOP COVER
There
are no adjustments
under the top
cover. To clean the engine
cooling
sys-
tem, follow
the steps below
to remove
the cover.
1.
Remove
screws
A that attach
the
rod support
clamp the the top cov-
er. Pivot
crank assembly
rod up
and lay on unit.
2.
Remove
screws
B.
3.
Remove
attachment
screws
C.
4.
Remove
the top cover,
5.
To install the top cover,
reverse
the
above
steps.
A
C
/
/
Crank
Assembly
Rod
Top
Cover
Figure lz
HOW TO REMOVE THE BELT COVER
1. Remove the screws A and nuts B
from the belt cover,
2. Remove attachment screw C from
the rear of the belt cover.
3. Remove the belt cover from the
unit.
4.
To install the belt cover,
reverse
the
above
steps.
NOTE: The belt cover has belt guides
moulded onto the inside of the cover. When
you install the belt cover, engage the auger
drive lever to tighten the belt against the
pulley. This wil! provide adequate clearance
for the belt guides when installing the belt
cover.
C
/
F-051009C
B
B
A
18
Belt Cover
A
A
A
Figure 15
Publicidad
