HOW TO ASSEMBLE
THE HANDLE
Install
Upper
Handle
1. Remove the T-knobs
and U-bolts
from the lower handle (Figure 2).
2. Put the upper handle in the operat-
ing position.
3. install the U-bolts and tighten the
T-knobs.
Note: Make sure that the cable is not
pinched between the upper and lower
handle, Make sure the cable is routed
as shown in Figure 2.
Attach
Auger
Drive Cable
1. Attach the auger drive cable to the
auger drive lever using the Z-hook
(Figure 3).
Adjust
The Upper
Chute
1. Remove the T-knob
and bolt on the
upper chute (Figure 4).
2. Rotate the upper chute to the operat-
ing position (past the lower chute
stop).
3. install the bolt and tighten the
T-knob.
Add Engine
Oil
1. The snow thrower was shipped with a
container of 5W30 engine oil. Before
operating, add this oil to the engine.
2. Remove the oi! fi!! cap/dipstick ac-
cess panel.
3. Remove the oil fill cap/dipstick
(Figure 5). Fill to the FULL mark on
the oil fill cap/dipstick. Periodically
check the oi! level. DO NOT OVER
FILL.
Add Fuel
1. Fil! the fuel tank with
fresh unleaded fue!.
2. To extend the life of the fuel and
prevent starting problems, add the
fuel stabilizer supplied with the
snowthrower.
DO NOT OVER FILL.
F-0510100
\
Upper
Handle
Cable
jure 2
Auger
Drive _
_
Z-Hook?//_Figure
3
Upper Chute
Lower Chute
k
T-Knob
Figure 4
II Fill Cap/D
Figure 5
NOTE: Oil level must be at FULL mark.