Publicidad
Idiomas disponibles
Idiomas disponibles
3. Pivot shield u ntil bolt p asses
through hole i nbracket.
4. Securely
tighten wing nut o nto bolt.
Slot
Wing Nut
Bracket
_/
St
Gearbox
Shield
KNOW YOUR TRIMMER
READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNIT. Compare the illustrations with your unit to familiarize yourself with the location
of the various controls and adjustments.
Save this manual for future reference.
Assist Handle
J
Trimmer
Shaft
Head
X4_
Shield
Starter Handle
ON/OFF
Switch
Primer
Bulb
Line Limiter
Blade
Throttle
Trigger
Start Lever
Muffler
ON/OFF
SWITCH
The ON/OFF switch is located on the
trigger handle and is used to stop the
engine. Move the switch to the OFF
position to stop the engine.
PRIMER BULB
The PRIMER BULB removes
air from
the carburetor
and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate the primer bulb
by pressing it and allowing it to return
to its original form.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Acti-
vate the starting system by moving the
start lever to the START position. DO
NOT squeeze
the throttle trigger until
the engine has started and runs. After
the engine starts, allow the engine to
warm-up
5 seconds,
then fully
squeeze
the throttle trigger to deacti-
vate the starting system (start lever
returns to RUN position).
BEFORE STARTING
ENGINE
,_WARNING:
Be sure to read
the fuel information
in the safety rules
before you begin. If you do not under-
stand the safety rules, do not attempt
to fuel your unit. Call 1-800-235-5878.
FUELING
ENGINE
_WARNING:
Remove fuel cap
slowly when refueling.
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good
quality synthetic 2-cycle air-cooled en-
gine oil. We recommend Craftsman
brand synthetic oil.
5
Publicidad
