AUX ALMD-NHA Serie Manual De Instalación Y Usuario página 96

Installation
Please confirm whether the parts are complete.
No.
1
The following tools shall be prepared on site.
No. Name
1 Electrical box 86 *86
Electrical tape
2
Big cross screwdriver
3
Small flathead
4
screwdriver
Installation schematic
1. Cut off the power of indoor unit.
2. As shown in Fig.1, use a flathead screw
river to pry the bottom groove of the wire
ontroller lightly (too much force would
amage circuit board), pry rotationally to
pen the back cover.
3. As shown in Fig.2, fix φ4 * 20mm screws
rovided together with the back cover on
ox, then pass lead wires through the
ack cover.
or
Name
Wire controller
Quanity
1
1
1
1
4. After connecting the connecting wire to the
main body of the wire controller, as shown
in Fig. 3, install main body part according
to the following steps:
1).Push the upper part of main body into the
2).Use the force of inclined top to install the
Fig.1
Fig.2
TIMER
FUNCTION
96
Remark
General electric box, embedded in wall.
To be used at the time of wiring.
For the installation of electrical box.
For dismantling the back cover of wire
controller.
clip.
lower part of main body (horizontal
installation is prohibited, which is easy to
damage the structural slot).
1
2
4 wires
CN4
(50m max.)
FAN SWING MODE
ON/OF
Quanity
1
Fig.3
IDU PCB