Lighting Instructions; Initial Cleaning - Pitco Frialator SG 14 Manual De Instalación Y Operación

listed on the data plate mounted on the inside of the fryer door..

LIGHTING INSTRUCTIONS

1. Solid State Thermostat: Switch melt switch to desired position. Turn the Thermostat
knob to desired temperature. Turn the power switch to the "ON" position, the fryer is equipped
with a matchless ignition system and will automatically light the pilot, and heat up to set
temperature.
2. Digital Controller: Press the
equipped with a matchless ignition system and will automatically light the pilot, and heat up to
set temperature.
3. Computer Controller: Press the
equipped with a matchless ignition system and will automatically light the pilot, and heat up to set
temperature.
DO NOT TURN COMBINATION GAS VALVE KNOB TO THE "ON" POSITION UNTIL
VESSEL IS FULL OF WATER OR SHORTENING. TURNING THE KNOB TO "ON" WITH VESSEL
EMPTY WILL DAMAGE THE VESSEL OR COMPONENTS AND VOID WARRANTY.

INITIAL CLEANING

When the fryer is shipped, many of its parts are covered with a thin coat of oil for protection. Before the fryer is ready
for cooking it must be cleaned. This will remove the oil coating and any foreign matter that may have accumulated during
storage and shipment. Perform the cleaning as described below.
a. Fill the tank with water and add one packet of Pitco fryer cleaner or a mild detergent, and turn gas valve knob
to ON position.
b. 1.
2.
3.
R6
Solid State Thermostat: Turn melt switch to the "MELT" position. Turn the Thermostat
knob to the lowest temperature setting (250
the fryer is now in the boil-out mode which will prevent the fryer from boiling over. Note:
do not leave the fryer unattended during this operation. Once the fryer has heated up to
0
approximately 195 F, allow it to operate for 15 minutes to allow any build up in the tank to
soften.
Digital Controller: Press the
will automatically switch into the boil-out mode which will prevent the fryer from boiling
over. Note: do not leave the fryer unattended during this operation. Once the fryer has
heated up to approximately 195
in the tank to soften.
Computer Controller: Press the
fryer will automatically switch into the boil-out mode which will prevent the fryer from
boiling over. Note: do not leave the fryer unattended during this operation. Once the fryer
has heated up to approximately 195
up in the tank to soften.
Do not leave the fryer unattended during cleaning. Never let the
water level go below the "Min Level" mark on the back of the tank.
button on the controller panel to turn fryer ON,
button on the controller panel to turn fryer ON, the fryer is
WARNING
0 F). Turn the power switch to the "ON" position,
button on the controller panel to turn fryer ON. The fryer
0
F, allow it to operate for 15 minutes to allow any build up
button on the controller panel to turn fryer ON. The
0 F, allow it to operate for 15 minutes to allow any build
NOTE
4
t
he fryer is