Craftsman 917.377282 El Manual Del Propietario página 11

PRODUCT SPECmFRCATIONS
MODEL NUMBER 917.377282
SERIAL NUMBER
DATE OF PURCHASE
HORSEPOWER: &0
DISPLACEMENT: It.6 CUo IN_
GASOLINE CAPACITY/TYPE: 1.6QUARTS
. UNLEADED REGULAR
OIL TYPE (API-SFiSG/SH): SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW 32°F)
OtL CAPACITY: 20 OZ&
SPARK PL.UG(GAP: .,030") CHAMPION RJ19L
VALVECLEARANCE: INTAKE: _005" - .007"
EXHAUST_ .007"- .009"
SOLID STATE IGNITION
AIR GAP: .010 IN.
BLADE BOLT TORQUE: 35..40 FT. LBS.
The model and serial numbers will be found on a decal attached to the rear of the
lawn mower housing.Record both serial number and date of purchase in space
provided above,
LAWN MOWER
Always observe safety rules when
performing any maintenance.
TIRES
. Keep tires free of gasoline, oil, or insect
control chemicals which can harm
rubber.
- Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may
cause tire damage.
BLADE CARE
For best results, mower blade must be
kept sharpo Replace bent or damaged
blades.
TO REMOVE BLADE
= Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug,
• Turn lawn mower on its side, Make sure
air filter and carburetor are up.
° Use a wood block between blade and
mower housing to prevent btade from
turning when removing blade bolt.
• Protect your hands with gloves and/or
wrap blade with heavy cloth°
o Remove blade bolt by turning counter-
clockwise, Use a 9/16" box or opemend
wrench.
o Remove blade and attaching hardware
(bolt. lock washer and hardened
washer),
NOTE: Remove the blade adapter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly. Replace adapter if damaged.
TO REPLACE BLADE
° Position the blade adapter on the engine
crankshaft° Be sure key in adapter and
crankshaft keyway are aligned.
- Position blade on the blade adapter
aligning the two (2) holes in the blade
with the raised lugs on the adapter,
. Be sure the trailing edge of blade
(opposite sharp edge) is up toward the
engine_
° Install the blade bolt with the lock
washer and hardened washei' into blade
adapter and crankshaft.
• Use block of wood between blade and
lawn mower housing and tighten the
1I