Theseaccessories wereavailable whenthislawnmower w asproduced° T heyarealso
available atmostSearsretail o utletsandService centers,MostSearsstorescanalsoorder
repairpartsforyou,whenyouprovide tilemodel n umber ofyourlawnmower.Someofthese
accessories m aynotapply to your' l awnmower.
LAWN MOWERPERFORMANCE
CLIPPING DEFLECTOR
-FOR REAR DISCHARGE
LAWN MOWERS
GRASS CATCHERS
FOR
REAR DISCHARGE
LAWN MOWERS
LAWN
MOWER
MAINTENANCE
MULCHER
KiTS
GRASS CATCHERS
FOR
SIDE D{SCHARGE
LAWN MOWERS
STABILIZER
GAS CANS
MUFFLERS
AiR FILTERS
BLADE ADAPTERS
WHEELS
SPARK PLUGS
ENGINE OIL
Read these instructions and this manual in its
entirety before you attempt to assemble or
operate your new lawn mower. 'four new lawn
mower has been assembled
at the factory with
the exception of those parts left unassembled
for shipping pu_oses_
All parts such as nuts,
washers, bolts, etc., necessary to complete the
assembly have been placed in the parts bag.
To ensure safe and proper operalion of your
lawn mower, all parts and hardware you
assemble must be lightened securely
Use the
correct tools as necessary to ensure proper
tightness.
TO REMOVE
LAWN
MOWER
FROM
CARTON
• Remove loose parts included with mower..
o Cut down two end comets of carton and lay
end panel down flat.
,, Remove all packing materials except
padding between upper and lower handle
and padding holding operator presence
control bar to upper handle..
- Roll lawn mower out of carton and check
carton thoroughly for additional loose parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD HANDLE
IMPORTANT:
UNFOLD HANDLES
CAREFULLY
SO AS NOT' TO PINCH OR
DAMAGE CONTROL
CABLES.
• Raise handles until lower handle seclion
locks into place in mowing position
• Remove prote_ve
padding, raise upper
handle section into place on lower handle
and tighten both handle knobs_
.
Remove hand!e padding holding operator
presence control bar to upper Ilandteo
o Your lawn mower handle cad be adjusted
for your mowing comfort,, Refer to "Adjust
Handle" in the Service and Adjustment
section of this manual
k 4