Descargar Imprimir esta página

Aiwa Z-HT63 Manual Del Usuario página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

For better
FM reception,
use of an outdoor
antenna
is
recommended.
Connect the outdoor antenna to FM 75 Q terminals.
To connect other optional equipment
+
page 30.
I
Inserting batteries
Detach the battery cover on the rear of the remote control and
inserf two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
If the remote control is not going to be used for an extended
period of time, remove the batteries
to prevent possible
electrolyte leakage.
The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
CD
To turn the power on
Press one of the function buttons (TAPE, TUNER, PHONO,
VIDEO/AUX or CD).
Playback of the inserted disc or tape begins, or the previously
tuned station is received (Direct Play Function).
POWER is also available.
To turn the power off
Press POWER.
Illumination
guides
Whenever POWER or one of the function buttons is pressed
after setting the clock, the buttons for the selected operation
light up or flash. (See "SETTING THE CLOCK on page 28.)
Flash windows
The window on the top of the unit and the cassette decks light
up or flash while the unit's power is on.
To turn off the light of the top window, press
CLEAR while
pressing CD. To turn back on, repeat the above.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
To change the brightness
level of the display
1 Press ECO so that "ECO MODE" is displayed,
2 Within 4 seconds, turn MULTI JOG to display "DIM MODE",
and then press ENTER within 4 seconds.
3 Within 4 seconds, turn MULTI JOG to select the dimmer mode
as below.
The mode will be automatically set after 4 seconds. It will
also be set if ENTER is pressed within 4 seconds after step
3.
r
DIM-OFF-DIMMER
1-DIMMER
2 *
DIMMER 3
-1
DIM-OFF: The normal display.
DIMMER 1: The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1.
DIMMER 3: The illumination of the display is dimmer than
DIMMER 2. The spectrum analyzer, the window on the top of
the unit, and the button lamps light off.
6
ENGLISH

Publicidad

loading