Using The Ac Adapter - Rohde & Schwarz ZPH Manual De Instrucciones

®
R&S Cable Rider ZPH
1. Unscrew the two thumb screws located on the battery compartment.
2. Open the cover.
3. Insert the battery into the R&S Cable Rider ZPH.
4. Close the cover and screw back the thumb screws.
You can operate the R&S Cable Rider ZPH with the AC adapter or the battery.
Both are included in the delivery.
3.1.4

Using the AC Adapter

Risk of instrument damage
To avoid instrument damage,
● Only use the power supply (R&S HA-Z301, order number 1321.1386.02)
included in the delivery.
● Make sure that the AC supply voltage is compatible to the voltage speci-
fied on the power supply unit.
● Attach the appropriate adapter to the power supply.
Connect the AC adapter to the DC port on the left side of the R&S Cable Rider
ZPH (item 1 of Figure
DC port.
Depending on the system you need, firmly connect the appropriate power cable
included in the delivery to the AC adapter (item 2 of
Finally, connect the power cable plug to an AC power outlet.
Getting Started 1321.0944.02 ─ 04
3-1). Make sure to fully insert the AC adapter plug into the
Preparing for Use
Putting into Operation
Figure 3-1 ).
12