Keeper KW17.5 Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

!
General Safety Warnings & Cautions (Continued)
FIGURE 6
FIGURE 7
21. DO NOT OPERATE WINCH WHEN UNDER THE INFLUENCE OF ANY DRUGS OR ALCOHOL.
22. ALWAYS DISCONNECT WINCH POWER LEADS TO BATTERY BEFORE WORKING ON OR AROUND THE
WINCH DRUM so that Winch cannot be turned on accidentally.
23. When moving a load, slowly take up wire rope slack until it is taut. Stop, recheck all Winching connec-
tions. Be sure the hook is properly seated. If a nylon sling is used, check the attachment to the load.
24. When using a vehicle mounted Winch to move a load, place the vehicle transmission in neutral (never in
Park), set vehicle hand-brake, and chock all wheels.
25. DO NOT USE THE WINCH TO HOLD LOADS IN PLACE. Use other means of securing loads such as
KEEPER brand tie-down straps. For tie-down information go to www.keepercorp.com
26. USE ONLY FACTORY APPROVED SWITCHES, ADAPTERS, REMOTE CONTROLS AND ACCESSORIES.
Use of non-factory approved components may cause injury or property damage and could void your
warranty.
27. DO NOT MACHINE OR WELD ANY PART OF THE WINCH. Such alteration may weaken the structural
integrity of the Winch and could void your warranty.
28. This is a 12 Volt DC Winch. CONNECT ONLY TO 12 VOLT DC BATTERY. DO NOT CONNECT WINCH TO
EITHER 110V OR 220V AC CURRENT AS WINCH WILL BURN OUT OR FATAL SHOCK WILL OCCUR.
This will void warranty.
29. Never allow shock loads to be applied to Winch or wire rope.
30. USE EXTREME CAUTION WHEN WINCHING A LOAD UP AND DOWN A RAMP OR INCLINE/.
31. Keep people, pets, and property clear of Winching path, front, rear and sides for 80'.
32. NEVER EXCEED RATING OF YOUR RECIEVER HITCH.
THIS PRODUCT IS NOT INTENDED FOR LIFTING / HOISTING
6
!
15. NEVER OBSCURE THE WARNING INSTRUCTION
LABELS ON THE WINCH.
16. It is highly recommended to lay a heavy cloth
(such as a blanket or tarp) over the wire rope
when pulling heavy loads (Figure 7). If a wire
rope failure should occur, the cloth will act as a
damper and help prevent the wire rope from
whipping. If mounted on the front of a vehicle
then raise the hood for further protection.
17. Always operate Winch with an unobstructed
view of the Winching operation.
18. Equipment such as hooks, pulley blocks, straps,
etc. should be sized for winch capacity and
periodically inspected for damage that could
reduce their strength.
19. NEVER RELEASE FREESPOOL CLUTCH WHEN
THERE IS A LOAD ON THE WINCH.
Sling
20. NEVER WORK ON OR AROUND THE WINCH
DRUM WHEN WINCH OR WIRE ROPE IS UNDER
LOAD.
Winch Installation
Correct installation of your Winch is required for proper operation. Installation should be on a flat surface
following the bolt pattern shown in FIGURE 1.
Read and follow directions carefully to ensure proper Winch alignment and trouble free operation.
This Winch MUST be mounted with the wire rope in the under-wind direction (FIGURE 8).
MUST use only genuine Keeper Winch replacement Wire Rope part number 92' x 15/32" KWA14624.
!
!
WARNING
Improper mounting could damage your Winch
and void your warranty.
!
!
WARNING
DO NOT EXCEED THE RATING OF YOUR RECIEVER HITCH
Step 1 Mount the Winch to the mounting kit
base plate, proper mounting bolts are
supplied. If using the Roller Fair Lead
included, install now to mounting plate.
You may need to remove one or more of
the rollers on the roller fairlead to pass
through the wire rope. After doing this you
may now attach the clevis hook. See
(Figure 8) for order and bolt direction.
Mounting Plate
4-Way
Roller Fairlead
THIS PRODUCT IS NOT INTENDED FOR LIFTING / HOISTING
FIGURE 8
Wire Rope
Under-wind
Direction
Does not include Mounting Plate (KWA14622)
7

Publicidad

Tabla de contenido
loading

Tabla de contenido