Important Notice - HoMedics TONY LITTLE DESIGNS AG-4000TL Manual De Instrucciones

1. Assembly

Important Notice:

If you experience any
Instructions/Components:
type of distortion or
Carefully remove all contents from packaging and inspect the
noise interference
product to make sure all components of the recliner have
when turning the unit
been received. These should include:
to the ON position,
• Left side frame
immediately turn the
• Right side frame with hand control pouch
unit off. Wait a few
• Crossbars (2)
seconds before
• Back and leg frames
• Bolt caps/nuts and washers (8)
turning the unit on
• Large bolts (8)
and
• Wrenches (3)
distortion/interference
• AC adaptor
should be eliminated.
• Wood caps
See Figure 1.
D
B
G
H
F
J
A
B
C
D E
F
G
H
I
J
A
C
C
E
I
4
Figure 2A
Figure 2B
Figure 3
Figure 4
Figure 5
Figure 1
2. Assemble Chair Base
Figure 2A
• Attach both crossbars to the left frame. Make sure to match the
corresponding number on the crossbar to the number on the frame.
• Insert the large bolts and tighten partially with the Allen wrench.
Figure 2B/3
• Attach both crossbars to the right frame, matching the corresponding
numbers.
• Insert the large bolts and tighten partially with Allen wrench.
3. Attach Seat/Leg Frame to Base
Figure 4
• On a soft or carpeted surface turn frame upside down.
• Slide Seat frame under the crossbar. Align the Seat frame
with pre-attached bolts to the frame, be sure to match the
corresponding numbers.
Figure 5/5A
• Place a washer and nut on each bolt to secure the seat
to the Seat to Chair Base. Use wrench to tighten partially.
Figure 5A
5