Cequent 37152 Instrucciones De Instalación página 13

VEHICLE FRAME
USE THIS HOLE
FOR CENTER
SECTION ASSEMBLY
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
93-98 JEEP GRAND CHEROKEE
1. Place the side brackets over the studs that are fastened into the bottom of the frame. Use holes 2 & 3.
Install 1/2" flat washers, lock washers, and 12mm nuts on the studs.
2. Drill a 1/2" hole into the frame using hole 1 as a guide. Thread 1/2 x 2 carriage bolt onto the pull wire
and place a 1/4 bolt plate over the bolt. Insert the free end of the pull wire into the top of the bumper
bracket. This is between the end of the frame and the bumper. Push it out through hole 1. Pull the bolt
down through the hole. Unscrew the pull wire. Install 1/2" flat washers, lock washers, and nuts on the
carriage bolts.
3. Install center section per SIDE BRACKET LOCATION 1. (See page 2)
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE
EXISTING STUDS IN FRAME
1/2" FLAT WASHER
1/2" LOCK WASHER
12MM HEX NUT
1/2 x 2" CARRIAGE BOLT
1/4" BOLT PLATE
DRILLED HOLE
1/2" FLAT WASHER
1/2" LOCK WASHER
1/2" HEX NUT
INSTALLATION K
TOOLS REQUIRED
19MM SOCKET
3/4" SOCKET
1/2" DRILL
TORQUE WRENCH
SAFETY GLASSES
HOLE #3
HOLE #2
HOLE #1