Installation - Alpine iDA-X200 Manual De Operación

Installation

Caution
Do not block the unit's heat sink, thus preventing air circulation.
If blocked, heat will accumulate inside the unit and may cause a
fire.
Heat sink iDA-X200 only
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Less than 35°
1
Mounting Sleeve
(Included)
Pressure Plates*
This unit
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Remove mounting sleeve from the main unit (see
"Removal" on page 43).
Detachable
Front Panel
Dashboard
2
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
attached to the vehicle's chassis.
2
• For the screw marked "* ", use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the iDA-X200/iDA-X300. Connect
all other leads of the iDA-X200/iDA-X300 according
to details described in the CONNECTlONS section.
3
Slide the iDA-X200/iDA-X300 into the dashboard
until it clicks. This ensures that the unit is properly
locked and will not accidentally come out from the
dashboard. Install the detachable front panel.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
3. Pull the unit out, keeping it unlocked as you do so.
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
1
) already
This unit
Bracket keys
(Included)
43
-EN