Failure
The Product is not sprayed
Oil is discharged from the
gun or drain
The motor overheats
The unit builds up too much
pressure
In accordance with Directive 2006/42/EEC AnNex II section A dated 17th of May 2006
Manufacturer:
Address:
Declare that the product:
Brand:
Model:
Is in conformity with the provisions of the EC Directive on machines (Directive 2006/42/EEC) including modifications of the
same and the corresponding incorporation into National Law. 1644/2008
For compliance with the requirements, the product complies with the standards:
Low Voltaje directive 73/23/CEE
Electro-magnetic Compatibility directive 89/336/CEE
Design and construction europen norms UNE-EN 292 (1 & 2), UNE-EN 989, UNE-EN 1050
International Norms CEI-34, VDE-0530/72
Complete technical documentation and product service instructions are available in the original version, as well as in the
community languages of the users.
Vitoria-Gasteiz, January 1, 2018
Cause of the failure
The product Filter is blocked
The Aircap is blocked
The purge stopcock is open or faulty
The anti-return valve is dirty or damaged
The motor thermal protection switch operated
The diaphragm is broken or punctured
Check to see if the equipment is being used at
pressures in excess of those permited
Incorrect power supply to the motor
Motor cooling air inlet is blocked
Motor bearings are worn
The pressure regulator is damaged
The is a fault in the hydraulic circuit
19. DECLARATION OF CONFORMITY
SAGOLA S.A.
Urartea, 6 · 01010 VITORIA-GASTEIZ (Álava) · SPAIN
ELECTRIC PUMP
SAGOLA
ATLANTA 500 / 800
Repair
Clean it or Replace it
Clean it and/or Replace it
Close it or replace it
Clean it or Replace it
The motor switch is off due to overheating.
Wait to cool and restart the job.
Replace the diaphragm
Check that the air inlet pressure regulator
operates correctly
Check the power supply to the motor
Place the equipment in a location where
the ventilator air intake is not impeded
Replace the bearings or the motor
Replace it
Send the unit to the S.A.T. SAGOLA
Enrique Sánchez Uriondo
- 26 -
Technical manager