Section 8. Twelve (12) Volt Installation - Jandy Pro Serie Manual De Instalación Y Operación

Page 12
ENGLISH
Black (12V)
Split
TP-2 (Black)
Washer
Serrated
TP-2
Washer
AC2
Black
Nut
12V Wiring LED Board
Figure 7. Small Light Engine (PCB) Replacement and Wiring
Green
Black (12V)
TP-2 (Black)
TP-2
AC2
Black
12V/120V Wiring
Figure 8. Large Light Engine (PCB) Replacement
and Wiring
Section 8. Twelve (12) Volt
Installation
A separate 12-Volt AC Transformer is required on all
12-Volt Models. For Jandy Pro Series White LED Light
use a 150-watt multi-tap 12-volt system per light.
WARNING
RISK OF ELECTRICAL SHOCK OR
ELECTROCUTION, which could result in serious
injury or death.
for supply connection of low-voltage
lights use only an isolating low voltage power supply
with ungrounded output, evaluated and listed by a
NRTL for swimming pool use.
Jandy Pro Series, White LED Lights
®
Green
White (12V)
LED Board
TP-1 (White)
Connector
TP-1
AC1
White
White (12V)
TP-1 (White)
TP-1
AC1
White
Serrated
Washer
Nut
Split
Washer
|
Installation Manual
120V Wiring LED Board
Align arrow of the
lens with the pilot
screw
Align pilot screw with
the arrow located on
the fixture label
Figure 9. Alignment of the Lens, Face Ring, Housing
and Clamps for White LED Lights
NOTE
For optimum performance Jandy Pro Series
recommends to use one transformer per 12-volt light.
To ensure maximum safety, it is strongly recommended
that a transformer that has been listed or recognized by
a Nationally Recognized Testing Laboratory (NRTL) for
the application be used.
Black (120V)
White (120V)
ACL (White)
ACN (Black)
LED Board
Connector
120V Wiring Driver Board