Wiring To An Aqualink ® Rs Control System; Wiring To A Time Clock; Wiring To A Switch - Jandy Pro Serie Manual De Instalación Y Operación

Page 8
ENGLISH
5.1 Wiring to an AquaLink
System
The Jandy Pro Series White LED Lights can be wired
into the Jandy Pro Series AquaLink
to provide simplified operation of the lights. Connect the
lights to one of the auxiliary relays in the Power Center.
NOTE
It is recommended to connect one light per relay so
each light can be controlled separately. However, up to
four lights can be connected on a single relay. If there
are more than four lights installed on one AquaLink RS
system, ensure there is more than one auxiliary relay
available in the Power Center.
Refer to Figures 2 and 3 to connect the Jandy Pro Series
White Lights to the Power Center.
WARNING
RISK OF ELECTRICAL SHOCK OR
ELECTROCUTION, which could result in serious
injury or death.
A Ground Fault Circuit Interrupter
(GFCI) must be provided for 120 volt models. A
Ground Fault Circuit Interrupter (GFCI) for 120
Volt transformers should be used if required by the
transformer manufacturer or if required by the local
applicable code and/or Authority Having Jurisdiction
(AHJ). When a GFCI is used, the conductors on the
load side of the GFCI circuit shall not occupy conduit,
boxes, or enclosures containing other conductors
unless the additional conductors are also protected by
a GFCI. Refer to local codes for complete details.
NOTE
The Jandy Pro Series White Lights are available in
120-volt and 12-volt versions. If installing a 12-volt
light, a NRTL certified 120-volt/12-volt step-down (AC)
transformer must be used. For more information about
12-volt installations, refer to Section 8 of this manual.
5.2

Wiring to a Time Clock

The Jandy Pro Series White LED Lights can be wired
into a basic time clock to automatically turn on the lights
at a predesignated time. Refer to Figure 4 to connect the
lights into the time clock.
5.3

Wiring to a Switch

The Jandy Pro Series White LED Lights can be wired
into a switch to manually turn on/off the lights. Refer to
Figure 5 to connect the lights into the switch.
Jandy Pro Series, White LED Lights
®
RS Control
®
RS control system
®
|
Installation Manual
120 VAC
Power Supply
GFCI
Neutral
Ground
Ground
Figure 2. 120-Volt Jandy Pro Series White LED
Light Wiring Diagram
120 VAC
Power Supply
Black
White
Neutral
Green
Ground
Figure 3. 12-Volt Jandy Pro Series White LED Light
Wiring Diagram
120V
LED
Light
Black Black
White
JUNCTION White
BOX
Green
Green
12V
LED
Light
Black
Black
White
120V/12V JUNCTION White
Transformer
BOX
Green
Green