tau K206MA Guía Para La Instalación página 18

Dip switch
AUTOMATIC
1
CLOSING
2 2 / 4 STROKE
CLOSES AGAIN
3 AFTER THE
PHOTOCELL
4 NO REVERSE
PRE-
5
FLASHING
6
FOTOTEST
MASTER/
7
SLAVE
BAR
8
LED
9-10-11 Selection of barrier model and bar lenght
Dip 9 Dip 10
Off Off
On Off
Off On
On On
Off Off
On Off
Off On
On On
IMPORTANT: In case the boom length change, a new setting of the dips # 9, 10 and 11
will be required. Before the new setup, however, it is necessary to proceed to a HARD
RESET (see page 24) of the controller.
12 SENSITIVE EDGE
MEMORIZATION PROCEDURE
6.
NOTE: Before starting the memorization procedure, make sure that the barrier boom is
perfectly balanced and that the mechanical limit switches of the boom are adjusted both in
when completely open, closure is automatic after the set time on the
On
T.C.A. trimmer has past.
Off the closing manoeuvre requires a manual command.
when the automation is operating, a sequence of opening/closing com-
On
mands causes the bar to OPEN-CLOSE-OPEN-CLOSE, etc.
in the same conditions, the same sequence of commands causes the
Off bar to OPEN-STOP-CLOSE-STOP-OPEN-STOP, etc . (step-by step function)
(see also dip switch
after the photocell is activated (input 7 - 9), the automation closes au-
On
tomatically after 1 seconds.
Off function off.
the automation ignores the closure command during opening and auto-
On
close time.
Off the automation responds as established by dip switch No. 2.
On the pre-flashing function is enabled.
Off
the pre-flashing function is disabled.
On the "photocell test" function is enabled.
the "photocell test" function is disabled.
Off
Note: to be used when the photocells are not used.
enables the MASTER mode in the master/slave configuration (see T-
On
COMM instructions).
enables the SLAVE mode in the master/slave configuration (see T-
Off
COMM instructions), or standard operation (single motor).
On when the boom is lifted all LEDs remain OFF.
when the boom is lifted all LEDs behave as per setting of wire terminals
Off
16-18 (default: FLASHING).
Dip 11 Modello
Off RBLO bar ≥ 2 m ≤ 2,5 m
Off RBLO bar > 2,5 m ≤ 3,5 m - RBLO-R 24 Vdc
Off RBLO bar > 3,5 m ≤ 4 m
Off
RBLO-L bar > 3,5 m ≤ 6 m
On
LUXE bar ≥ 4 m ≤ 4,5 m (including accessories)
On
LUXE bar > 4,5 m ≤ 5,5 m (including accessories)
On
LUXE bar > 5,5 m ≤ 6,5 m (including accessories)
On
LUXE bar > 6,5 m (including accessories)
On
RESISTIVE SENSITIVE EDGE (terminal No. 10).
FIXED EDGE (NC contact – terminal No. 10).
Off
Note: if not used, keep the DIP in the OFF position.
4).
18