tau K206MA Guía Para La Instalación página 20

DL4 - Green CLOSE button LED signal
DL5 - Green PHOTOCELL LED signal
DL6 - Green
SENSITIVE EDGE LED signal
LED - DL7
Apart from highlighting the presence of the battery, LED DL7 displays any mistakes with a series of
pre-set flashes in various colours:
Key: led always on;
always on:
(green)
always on:
(yellow)
1 flash every 4 seconds:
(green)
1 flash every 4 seconds::
(yellow)
1 flash every 2 seconds:
(red)
fast flashing:
(red)
LED - DL8
The DL8 LED indicates mistakes in the board logic with a series of pre-set flashes in different colours:
Key: led always on;
1 flash every 4 seconds:
(green)
/ alternate flashing:
(red/green)
fast flashing: (yellow)
1 flash:
(red)
1 flash: (yellow)
2 flashes:
(red)
3 flashes:
(red)
4 flashes:
(red)
5 flashes:
(red)
6 flashes:
(yellow)
7 flashes (red):
8 flashes:
led flashing;
fully-charged battery, main voltage present;
battery charging;
fully-charged battery, no main voltage;
Check the main voltage;
power supply through photovoltaic panel (terminals 1-2), battery
charger disabled
low battery;
Charge the battery, replace the battery;
faulty battery;
Replace the battery;
led flashing;
normal operation;
saving to be performed;
learning process;
phototest error
Disable phototest (dip-switch 6 OFF), check the operation of the photocells
and their connection;
unknown status, next operation REALIGNMENT;
obstacle for motor;
Check there are no obstacles on the path of the bar and its balancing;
no motor encoder signal;
Check wiring, check encoder by TEST-ENCODER (optional);
no motor signal;
Check wiring, check the motor rotates freely and is powered directly by the
battery, check fuse F5;
max current limit for motor exceeded;
Excessive absorption peaks of the gearmotor, check there are no obstacles on
the bar path, check the current absorption of the motor when in a no-load
condition and when applied to the bar;
master/slave communication error;
Check wiring between the controllers, efficiency of slave controller (fuses),
efficiency of interface boards;
Sensitive edge safety intervention
A command pulse is required to carry out the closure;
Eeprom external memory fault;
20