Assembling The Fittings And Pipes - Aqua-Base ESW Serie Manual De Utilización

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.4 – ASSEMBLING THE FITTINGS AND PIPES
Assembling the fittings.
The fittings must be absolutely clean. Clean the fitting and its housing beforehand by removing any remaining
scraps of Teflon.
Wind Teflon round the fitting thread, turning clockwise (see the picture).
Place the fitting in its housing and tighten by hand.
Ensure tightening with a slight turn of a spanner.
Assembling of pipes.
The cut, using a cutter; should be clean, without mistakes and perpendicular to the axis of the pipe.
The hoses used must resist to a minimum pressure of 20bar. If needed, SLCE can supply the following references
références 717303 (hose 8x13 20bar) et 717276 (hose 19x27 20bar).
The produced water pipe (F) is connected to the upper part of the tank and should not touch the water.
Don't put a valve on this production pipe (because there is no rise in pressure); if a valve is installed on this tank, then it must be
always open (water must be able to pass freely into the tank).
Do not immerse the piping into the tank to avoid an effect of "siphon"
in the stopping of the watermaker.
The rinsing (E) and cleaning (D) pipes are long enough to be immersed simultaneously in an auxiliary
bucket placed on the ground, during membrane rinsing and cleaning operations.
The pipe (E) will be placed preferably partly lower than the rinsing tank to assist the starting of the pump.
To assemble a pipe on its fitting, proceed as shown on the figure :
1- Place the hose clamp, without tightening, then place the pipe on the fitting,
2- Slide the hose clamp to the fitting level and tighten it,
3- To dismantle the pipe, slide the clamp with the help of a screwdriver, then free the fitting tube
Remark : SLCE releases any problem of break of flexible hose between outlet of the booster pump and the inlet of the exchanger, if the
flexible hose used was not validated by our technical service.
J:\Etude-3d\Aquaset\0-DOSSIER TECHNIQUES\1-sw-plaisance\ESW\00-ESW 0707\09- Manuels Utilisateur\DOC UTILISATEUR ESW FRUKES 2009-10-C.doc
.
FR/UK/ES Page 26/58
VERSION 2009-10-C

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Esw 301Esw 302Esw 602

Tabla de contenido