Final Steps - Jacuzzi Anima Design Manual De Instalación

Also raise the front panels b and c, in the same way.
(detail 4-5) Check that:
- the panels are perpendicular to the wood skirt.
- the respective vertical sides are parallel to one another and
that the indicated distances are complied with.
- the lower edges of the panels are aligned.
Any adjustments should be made via the slots of the brackets.
(detail 6) Lock the panels in the final location using the indicat-
ed nuts.
Do the same for panel d.
Finally, remove the spacers from below the panels

Final steps

i
I
( 32, detail1) Install the covering panels by inserting them in
the groove under the tub edge; (detail 2) check that, in the lower
part, the pegs (r1) are inside the unloaded parts (r).
Note: the covering panels can be mounted on any side, even
upside down.
I
Check coupling with the front and side panels. Also make sure
that the lower edge of the covering is aligned with that of the pan-
els. Use the brackets as needed to make adjustments.
I
(detail 2) Then fasten the covering panels using the fastening
system (s-s1).
i
I
( 33) Position the headrest (included) on the edge of the tub
as indicated.
9