Set Up Procedure - Digitus DC/DC Manual Del Usuario

SET UP PROCEDURE

1. Consult the enclosed list to make certain that your notebook is
compatible.
2. Check the recharging voltage of the battery of your notebook, by
consulting the manufacturer's instruction manual. (Should this not
be possible, the recharging voltage is marked on the body of the
battery).
3. Make certain that the maximum power required by your notebook
is less than 72W.
4. The positive pole is located on the internal coaxial connector.
5. Select the right fuse for the recharging voltage of the battery
(Purple 15V, Blue 16V, Red 18V, Green 19V, Black 20V, Orange
24V)
and fi t it into the appropriate slot on the device, making sure that it is
pressed fully home.
6. Consult the compatibility list included in the pack to select the tip
that is best suited to your notebook, (A 6.5mm x 4.5mm, B 6.3mm
x 3.0mm, C 5.5mm x 2.5 mm, D 5.5mm x 2.1mm, E 4.75mm x
1.7mm, F for most Dell models, G for all Apple models).
7. Once you have selected the correct tip, connect it to the plug,
taking care not to force it (the clip on the plug has to clip into the
notch on the tip).
DA-10213 Rev. 1.2
9