Emerson DL8000 Instrucciones Para Un Uso Seguro página 5

Figure 3. Views of the DL8000
The following tools are required for installation,
maintenance, and troubleshooting:
Personal computer running Microsoft
▪
Windows 8.1, or Windows 10 and Emerson Field Tools
configuration software (providing ROCLINK™ 800
configuration software).
Phillips (cross-head) screwdriver.
▪
4.5mm (1/8 inch) flat-head screwdriver.
▪
Torque wrench with 8mm hex key.
▪
Unpacking
You receive the DL8000 and a hardware kit containing
additional bolts required for installation in a box. Remove
these items from the box. Examine the packing list
carefully to ensure you have all components.
Installation
1. The loading facility's design predetermines the
location of the DL8000. The cover hinges at the
www.Emerson.com/RemoteAutomation
Safe Use Instructions – Emerson DL8000 Preset Controller
Windows 7,
® ®
bottom side and opens down for access to the internal
electronics. The unit ships with one bolt that secures
the cover to the case. This bolt may be removed and
discarded during initial installation of wiring. Route all
conduit to the bottom of the unit. Do not locate any
object under the DL8000 or in front of the conduit for
a distance of approximately 380mm.
You are responsible for fabricating mounting
fixtures for the DL8000. Mounting height is
approximately 1.14 to 1.27 meters above grade to
the bottom of the DL8000 case.
Four M10-1.5 x 15mm threaded bolts are provided
for mounting the DL8000. The enclosure can be
bottom-mounted or rear-mounted. Bottom-
mounting is preferable, due to the weight of the
device. The lengths of the bolts provided are sized
for use with a 4mm-thick mounting panel. In the
event a different thickness panel is used, select bolts
of an appropriate length in order that when they are
fully tightened without washers fitted, a thread
remains free (therefore, where it is intended to fit
washers, even if they are inadvertently not fitted, a
thread remains free and the bolt will not bottom
Part D301347X412
February 2018
3